Electric Automation Forum
Forum » General Discussion

General Discussion

Everything about electric automation industries, like motor control, motion control, industrial communication, software etc, and the newest technologies around the world.
Post New Thread
Title/Thread
Last post by
400 kV transmission line charging
Started by Ashish,09-09-2013 09:34 PM
Replies: 8
Views: 3810
Umesh
09-11-2013 09:23 PM
Best place to inject signal for loop gain measurements?
Started by Hadrien,09-10-2013 06:00 AM
Replies: 5
Views: 2889
Merren
09-10-2013 06:02 AM
Active Flyback Snubber Question
Started by Jay,09-10-2013 05:51 AM
Replies: 8
Views: 3243
Jay
09-10-2013 05:55 AM
What Do You Do When There is No Model?
Started by Ray,09-09-2013 11:11 PM
Replies: 11
Views: 2359
Kadir
09-09-2013 11:17 PM
Fundamental Power Conversion Book
Started by Martin,09-09-2013 11:04 PM
Replies: 7
Views: 2082
Marty
09-09-2013 11:09 PM
High Current Inductors
Started by Luke,09-09-2013 10:39 PM
Replies: 5
Views: 2407
Merren
09-09-2013 10:41 PM
Current Mode Control
Started by Ray,09-09-2013 06:39 AM
Replies: 11
Views: 2733
Ray
09-09-2013 06:44 AM
Replies: 6
Views: 1660
Alex
09-09-2013 06:30 AM
The basic test equipment list of the power engineer?
Started by Marty,09-09-2013 06:19 AM
Replies: 8
Views: 1909
Paul
09-09-2013 06:26 AM
Low cost controller with integrated switch
Started by Stephen,09-09-2013 06:09 AM
Replies: 11
Views: 2012
Anthony
09-09-2013 06:16 AM
Free-wheeling diode question
Started by Jay,09-09-2013 05:58 AM
Replies: 11
Views: 3271
Charlie
09-09-2013 06:04 AM
Looking for 300A/250V DC SSR
Started by Wissam,09-09-2013 05:44 AM
Replies: 2
Views: 2101
Kamran
09-09-2013 05:44 AM
Replies: 10
Views: 2244
Reynald
09-09-2013 05:42 AM
Half-Bridge Converter Design - Current Control
Started by Fellipe,09-09-2013 05:23 AM
Replies: 17
Views: 4090
Fellipe
09-09-2013 05:34 AM
Digital control solutions vs. analog control solutions?
Started by Marty,09-09-2013 04:39 AM
Replies: 9
Views: 2174
Ron
09-09-2013 04:49 AM
Replies: 6
Views: 2637
Charlie
09-08-2013 11:49 PM
1 << 26 27 28